Oil sampling Vacuum Pump
Use our oil sampling Vacuum Pump for engine, transmission, or gearbox sampling through the dipstick or access hole.
Instructions:
1. Remove the sample jar cap.
2. Attach the tubing to the Vacuum Pump and insert the tubing into the oil reservoir through the dipstick tube or access hole.
3. Actuate the pump until the oil sample comes up the tubing and fills the sample jar approximately 3/4 full.
4. Throw away the tubing section after the sample is taken (never reuse the tubing section). Put the cap on the sample jar.
5. Fill out the sample jar label completely and attach it to the sample jar.
It's that simple!!
Note: Always use a fresh tubing section for any oil sample.